CaveVan Forum
CaveVan Stuff! => CaveVan Stuff => Topic started by: Cole on April 05, 2016, 03:02:28 pm
-
;)
http://cavevan.myshopify.com/products/cavevan-real-word-replacement-tables-for-eurovan-weekender
(http://cdn.shopify.com/s/files/1/0904/7278/products/IMG_0012_1024x1024.JPG)
-
I love it... But I've got a 97 mv not a 93 or a 99-03... Any options for me?
...tapped out with just a thumb
-
Where did you get a 97MV?
In the USA they were all either 93/99-2003.
The way the table latches changed.
Send me a picture of your latch on the table itsef and I can make you a table or at least figure out which category the 97 fits into.
-
Sweet! But it'd be even sweeter with matching panels for the upper bunk.
Sent from my SM-N920T using Tapatalk
-
Sweet! But it'd be even sweeter with matching panels for the upper bunk.
Sent from my SM-N920T using Tapatalk
The rear upper bunk panel is glued and riveted down. After drilling out the 11 rivets you have to break off the upper rear board. It will leave part of its wood stuck to the van frame. Which of course then needs removed.
The metal frame for both front and rear board along with the mount tabs then need to be drilled out and removed from the old boards and attached to the new boards with new hardware.
Then the rear board needs glued and riveted back into the van as its a structural piece of the van itself.
Much harder and more invasive than just unscrewing them and screwing them back into place, like the table.
Also really big items to ship.
This is why I've only offered them as an installed item.
-
Makes complete sense, I didn't know they were attached so permanently. It may have to be just a table then!
Sent from my SM-N920T using Tapatalk