Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - wildenbeast

Pages: [1] 2 3 4
1
Inline 5cyl Petrol engine tech / Re: timing belt tensioner-93 eurovan
« on: November 21, 2018, 08:34:01 am »
That first link is actually the same as buying from Van-again.  I didn't know Ken sourced those from Germany.  He has a lot of good parts for 2.5L vans.

3
CaveVan Stuff / Re: Lift Kit effect on other components
« on: February 21, 2018, 08:52:44 am »
Cole installed a lift, new Bilsteins, and 16" wheels on my van a few years ago now.  Afterwards, I had an alignment done and the shop set my van at a bit nose down as well. 

4
CaveVan Stuff / Re: Seat swivel 2001 Eurovan weekender
« on: February 13, 2018, 08:56:22 am »
Do their passenger swivels have the attachment to install the extra rear facing seat?  I am looking for a base that is already lowered but still has that attachment pin.

5
CaveVan Stuff / Re: Seat swivel 2001 Eurovan weekender
« on: February 08, 2018, 09:10:25 am »
The battery size doesn't change because of the swivel.  You cannot put heated seats through the Eurocamper swivels.  However, you can run heated seats through the swivels that Bus Depot carries.  I hope this helps.

7
CaveVan Stuff / Re: Questions about the CaveVan Pop-Top Retrofit
« on: November 21, 2017, 08:57:02 am »
Cole has at least 2 or 3 of this type of build documented on the Samba.  Here's one of them:
https://www.thesamba.com/vw/forum/viewtopic.php?t=537597&highlight=cavevan

8
Want to buy something? / Re: Wanted - MV pop up table
« on: October 27, 2017, 09:01:35 am »
There's one on the Samba classifieds right now for a good price:
https://www.thesamba.com/vw/classifieds/detail.php?id=2014448

9
Show off your projects here! / Re: Scamper Van
« on: September 20, 2017, 09:27:46 am »
Nice job on the SketchUp models.  I look forward to seeing them become the real thing.

10
CaveVan Stuff / Re: Weekender cabinet
« on: July 13, 2017, 09:02:13 am »
I would definitely want one of these.  I have been looking at the European ones for awhile now.  Since I have a '93, I am wondering if you will make a narrower version as well?  So that the two small doors on each side of the van can stay in place?


11
Westfalia / Re: Where do you guys buy/find parts from?
« on: February 06, 2017, 09:55:16 am »
I have a long list of new / used parts vendors saved on a Shutterfly Site:
https://billwildenberg.shutterfly.com/vweurovan

12
Inline 5cyl Petrol engine tech / Re: Pistons for a '95 ACU engine rebuild
« on: November 29, 2016, 04:12:30 pm »
If you want to increase bore and stroke, Overland Parts sells the pistons you need (also expensive at $1308 for the set).  Go to page 30 of their online catalog and you will see:
EFP 107 2705 4VT 9.1, PISTON SET, INCLUDES PINS, CLIPS AND RINGS, JE, 5 CYL, 83.0MM BORE, 100MM STROKE. 9.0:1 C/R.

I am seeing the stock ones on sale for $216 each:
http://www.jimellisvwparts.com/products/gb/Volkswagen-VW/EuroVan/Piston-complete/5128657/023107065A.html?partner=googlebase_adwords&kwd=&origin=pla

Bill

13
General Discussion / Re: Eurovan syncro USA rollcall!!
« on: November 21, 2016, 09:54:16 am »
I would contact these guys:
http://www.dasmule.com/protection/

When I spoke to them over 6 months ago, they said they were doing some Eurovan work as well.

14
Show off your projects here! / Re: The Thermos Project
« on: August 23, 2016, 05:09:54 pm »
Can you tell us a bit more about the bench seat doors / covers you made?  They look nice.

[/URL]

Pages: [1] 2 3 4