It took about 1500 miles (and maybe a bit of trailer pulling) to sufficiently wear out the right-side engine mount which I reused from the gasser.
With the idea of cutting down vibrations, I ordered a hydraulic mount for the ABL, but unfortunately made the mistake of getting a >'96 mount. I surmise that the later vans' brackets are mounted higher on the frame, because the mount is a lot taller. It fits, but the engine is unacceptably lower and it vibrates a whole lot more than before.
Should I just replace it with a new stock gasser mount (701199201H) or a plain bonded rubber 90-95 ABL mount (701199201G)? Has anyone else explored options for cutting down vibrations in the cab?
Andrew