Hello all --
Pulled my ECU the other day and shipped it off to be repaired after my mechanic said it was showing a MAP sensor fault. The good news is that it tested fine, didn't need to be repaired and my '95 Eurovan so far seems to be running fine -- not showing any of the symptoms it showed before. The bad news is the CEL is on constantly, beginning just a few seconds after starting. Tried to reset it by disconnecting the battery and touching the battery cables, but the CEL came on again just as before.
Rather than go through the hassle of getting the codes read again, I'd prefer to reset the CEL and see if it reappears. Any ideas on how to do that without tracking down a scanner? Any other thoughts? Thanks.
--John