Hoping Cole can weigh in on this. Right side nut on the torsion bar is seized. Tried PB Blaster, a torch, air impact wrench. Noting moving. Left side is fine. Jacked van up on stands and gave it 2 hours of my life. Trying to level the van. Front is 2" lower than the front. Want to raise the front a little over an inch.
Has anyone had to remove and replace the torsion bar bolt? I suspect I can get a new one in OK but I'm not sure I'll have enough room in there to get a new one into the torsion bar and into place in it's notch in the frame.
Thanks for your help on this.