Looks good Cole! Any modification to the rebar required behind that?
The ALPINE ILX-007 is very thin. But not thin enough.
I figured I had to try it and see what it really took to install one of these without the European, unicorn, double din dash bar. So this was purely an experiment.
I still had to trim about 25mm off the dash support. This is better than cutting it all the way through, but still not the most awesome solution.
This is what it looks like behind the dash stock.
You need to trim this little trim plate out.
Then I cut a 25mm deep section out of the center dash bar. Trying to leave as much of that bar intact as I could.
It's not as clean behind the scenes as I prefer.